Overview

The LWGY series turbine flow sensor (hereinafter referred to as the sensor) is a velocity-type flow meter based on the principle of torque balance. The sensor features a simple and lightweight structure, high accuracy, excellent repeatability, rapid response, and ease of installation, maintenance, and use. It is widely used in industries such as petroleum, chemical engineering, metallurgy, water supply, and papermaking, making it an ideal instrument for flow measurement and energy conservation.

The sensor is designed for use with display instruments and is suitable for measuring liquids in closed pipelines that do not corrode stainless steels 1Cr18Ni9Ti and 2Cr13, as well as alumina Al2O3 and cemented carbides, provided the liquids are free of fibers, particles, and other impurities. When paired with display instruments equipped with special functions, this sensor can also perform quantitative control and over-limit alarms. The explosion-proof version (ExmllT6) of this product is available for use in environments with potential explosion hazards.

The sensor is suitable for media with a viscosity of less than 5×10⁻⁶ m²/s at the operating temperature. For liquids with a viscosity greater than 5×10⁻⁶ m²/s, the sensor must be calibrated using actual liquid samples before use. If users require sensors in special configurations, they may negotiate and place orders accordingly. When an explosion-proof sensor is needed, please specify this requirement when placing the order.

Structural Features and Working Principle

(1) Structural Features

The sensor features a thrust-type design with cemented carbide bearings, which not only ensures high precision and enhanced wear resistance but also boasts a simple, robust structure that is easy to assemble and disassemble.

(2) Operating Principle

As the fluid flows through the sensor housing, the blades of the impeller, which are angled relative to the flow direction, experience a force exerted by the fluid. This force generates a torque that causes the blades to rotate. After overcoming the frictional torque and fluid resistance, the blades begin to spin steadily once torque equilibrium is achieved. Under certain conditions, the rotational speed is directly proportional to the fluid velocity. Since the blades are ferromagnetic, they enter the magnetic field generated by a signal detector—comprising a permanent magnet and a coil. As the rotating blades cut across the magnetic field lines, they periodically alter the magnetic flux passing through the coil, thereby inducing electrical pulse signals at the coil’s terminals. These signals are then amplified and shaped by an amplifier to form continuous rectangular pulses of a specific amplitude, which can be transmitted over long distances to display instruments, allowing them to indicate either the instantaneous flow rate or the total accumulated flow of the fluid. Within a certain flow range, the pulse frequency f is directly proportional to the instantaneous flow rate Q of the fluid passing through the sensor; the flow equation is:

In the formula:

f: Pulse frequency [Hz];

k— The meter coefficient of the sensor [1/m³], provided by the calibration certificate;

Q— Instantaneous flow rate of the fluid (in operating condition) [m³/h];

Conversion factor for 3600 seconds.

The meter coefficient for each sensor is filled in the calibration certificate by the manufacturer. After the k-value is entered into the corresponding display instrument, it can display both the instantaneous flow rate and the cumulative total.

Basic Parameters

Medium temperature: -20～+120℃. Ambient temperature: -20～+65℃.

Power supply: Voltage: 24VDC, Current: ≤10mA.

When powered by batteries, the current consumption is 3.6V/0.3mA. The 485 communication current increases by 0.6mA. Transmission distance: The distance between the sensor and the display instrument can reach up to 1000m.

Selection

Flow range and pressure rating

External dimensions

Flow range and pressure rating

Factory display

Honor Show

Exhibition style